I was able to create the main loft of the bottle body in-class, but created the lip details and lid at home.
I used the spline tool together with a combination of imported photos and a vernier caliper to produce profiles for front, side, top and bottom views.
The front side view
At first I tried using the splines defining the sides of the bottle as 'profiles' with the top and bottom as 'guide curves' but this caused an error. I tried swapping them and was able to successfully create the loft.
Isometric view of the lofted body
Thursday of week 2 I continued work on this bottle.
I measured the bottle top with a vernier caliper and created accurate extrusions, then hollowed the body with the shell tool.
Isometric view of the shelled body
I then measured the details around these extrusions and created them.
Isometric view of the bottle lip
No comments:
Post a Comment